ESP RFID Tool

Descripción

The Generic ESP RFID Tool is a WiFi-enabled interface for authorised testing of access-control installations that use the Wiegand protocol. It can capture raw data from connected reader wiring and provide access to logs through a web interface, supporting controlled assessment of RFID readers, keypads and other Wiegand devices.

Key features

• Captures raw binary data from standard 5V Wiegand interfaces.
• Designed for testing access-control readers and related Wiegand equipment.
• Supports common 26 to 37-bit HID card formats as a primary target.
• Provides a web-based interface over WiFi.
• Can operate as a WiFi access point or connect to an existing WiFi network.
• Uses a four-wire connection for power, ground and Wiegand data lines.
• Open-source software is available through the project repository.

Technical details

• Hardware platform: ESP12 WiFi module.
• Interface: WiFi with TCP/IP support.
• Wired protocol: standard Wiegand.
• Operating voltage: approximately 4.5V to 12V, based on the project documentation.
• Connection: four-wire interface for power, ground, D0 and D1.

Compatibility and setup

Use the supplied auto-splicing connector with compatible Wiegand wiring, following the relevant wiring documentation and the system owner’s approved test plan. The project provides firmware releases, source code and installation schematics. A WiFi-capable phone or computer can access the web interface. Compatibility depends on the reader’s wiring and protocol, so verify the installation before connection.

Buying in the UK and EU

RedKit Labs lists the Generic ESP RFID Tool for professional security teams, penetration testers and researchers, with prices shown in GBP, EUR or USD and VAT handled at checkout. Use only with explicit authorisation and review applicable access-tool, data-protection and security laws. Transmitting is regulated by national radio rules and licence-exempt bands in the UK and EU; receiving and analysing authorised signals is the common lawful use.